VirtualHW.productCompatibility = "hosted"ĮxtendedConfigFile = "Test Pharos PS.vmxf"Įthernet0.generatedAddress = "00:0c:29:64:09:63" Ide1:0.fileName = "C:\Users\%username%\Documents\ISOs\peboot.iso" If anyone can help me out, I would be insanely grateful. I have attached a vmx file for a Windows XP (currently only booted into WinPE) guest configured with bridged and the IP information for both host and guest. "QualifyingDestinationThreshold"=dword:00000003 "DontAddDefaultGatewayDefault"=dword:00000000 "SyncDomainWithMembership"=dword:00000001 For some reason DisableTaskOffload shows in the regedit GUI, not the text export. Subsequently, I did try adding the DontAddDefaultGateway, EnabledRSS, and DisableTaskOffload keys to my CurrentControlSet on the I have tried toggling all of them, specifically those mentioning offload, all day to no avail. Wake Up Capabilities (Magic Packey tried None) Speed & Duplex (Knew better than to mess around here, has made problems in the past left at Auto) Priority & VLAN (Priority & VLAN Enabled tried Priority & VLAN Disabled) So, as I was saying, I was unable to find the settings from this post As a result, I upgraded from driver versionġ2.2.2.1 (b57nd60a.sys) from 10.100.0.0 (I think, cannot rollback driver now to check since I need to work on some VMs for urgent Sure if that is a driver difference between 32-bit and 64-bit implementations. This is quite similar to the OP for that thread. I am not able to find the settings mentioned in the post linked above. It is important to disable offloading, but So, for those not familiar with Broadcom driver problems, they are apparently numerous. Posts, but nothing appears to be helping. I disabled VMNet0 and everything because it flat out was not working. This is even after I set up a custom adapter (VMNet2) that bridges explicitly to this problematic NIC. I have tried several different guest operating systems, and all DHCP requests are ending up in APIPA. Unfortunately, it appears the biggest problem is the network adapter. The system is a Dell Optiplex 745 upgraded to 8GB of Upgrade hoping for a quick fix) as a rapid imaging development and testbed. I am trying to create a development environment that uses VMWare Workstation 7.0.1 (and tried with 7.0.0 before, leading me to All, I am new to the forum but have been reading up on a problem that has been driving me up a wall.
0 kommentar(er)
